HP 8753E - Valid Characters; Units

Valid Characters
The analyzer accepts the following ASCII characters:
n letters
n numbers
n decimal points
n +I-
n semicolons (;)
n quotation marks (“)
w carriage returns (CR)
w linefeeds (LF)
Both upper- and lower-case letters are acceptable. Carriage returns,
leading zeros, spaces, and unnecessary terminators are ignored, except
for those within a command or appendage. If the analyzer does not
recognize a character as appropriate, it generates a syntax error message
and recovers at the next terminator.
Units
The analyzer can input and output data in basic units such as Hz, dB,
seconds, etc.
S Seconds
Hz
Hertz
V Volts
DB
dB or dBm
Input data is assumed to be in basic units (see above) unless one of the
following units is used (upper and lower case are equivalent):
MS Milliseconds
KHZ Kilohertz
US Microseconds
MHZ Megahertz
NS Nanoseconds
GHZ Gigahertz
PS Picoseconds
FS Femtoseconds
HP-IB Programrm
‘ng and Command Reference Guide l-9