HP-IB Operational Capabilities
On the network analyzer’s rear panel, next to the HP-IB connector,
there is a list of HP-IB device subsets as defined by the IEEE 488.2
standard. The analyzer has the following capabilities:
SHl
Full-source handshake.
AH1
Full-acceptor handshake.
T6
Basic talker, answers serial poll, unaddresses if MLA is
issued. No talk-only mode.
L4
Basic listener, unaddresses if MTA is issued. No listen-only
mode.
SRl
RLl
PPO
DC1
DTl
Complete service request (SRQ) capabilities.
Complete remote/local capability including local lockout.
Does not respond to parallel poll.
Complete device clear.
Responds to a Group Execute Trigger (GET) in the
hold-trigger mode.
Cl
,C2,C3
System controller capabilities in system-controller mode.
Cl0
Pass control capabilities in pass-control mode.
E2
Tri-state
drivers.
LEO
No extended listener capabilities.
TEO
No extended talker capabilities.
These codes are completely explained in the IEEE Std 488 documents,
published by the Institute of Electrical and Electronic Engineers, Inc.,
345 East 47th Street, New York,
New York 11017.
l-20
HP-IB
Progr-
‘ng and Command Reference Guide
To Next Page
Loading...
