Table
l-11.
HP-IB
Only Commands (continued)
Action Mnemonic s ?
Description
LIMIT LINE AND DATA POINT TEST
linfmax
MINMAX<ONIOFF>
*
2 1,0 Enables/disables min/max recording per
ecording
segment. Min and max values are recorded
per limit segment.
egment
SEISEG[D]
*
3
D Selects segment number for the OUTPSEGF
and OUTPSEGM commands to report on. D
can range from 1 to 18.t
,a&
point
SELMAXPT[D]
3
D Selects the last point number in the range
o
points that the OUTPDATR command will
report. D can range from 0 to the number
01
points minus 1.
Prst
point
SELMINPT[D] 3
D Selects the first point number in the range
of points that the OUTPDATR command will
report. D can range from 0 to the number
01
points minus 1.
pecify
SELPT[ D] 3
D Selects point number that the OUTPDATR
oint
command will report. D can range from 0
to
the number of points minus 1.
MENUS
,veraging
MENUAVG
1
:alibration
MENUCAL
1
OPY
MENUCOPY
1
lisplay MENUDISP
1
brmat
MENUFORM
1
[arker
MENUMARK
1
[eas
MENUMEAS
1
[arker
MENUMRKF
1
mction
‘ff
MENU<ONIOFF>
2
ave Recall MENURECA
1
ave
Recall
MENUSAVE
1
tale
MENUSCAL
1
equencing MENUSEQU
1
timulus
MENUSTIM
1
ystem
MENUSYST
1
Refer to the “Limit Line and Data Point Special Functions” section in HP
I&SIC
Vogramming
Examples
Guide
For the definition of a limit segment, see “Example Display of Limit Lines” in the
rP
RASIC
Programming
Exumples G&de section titled “Limit Line and Data Point
pecial Functions.”
l-94
HP-IB
F’ro@ammi
ng and Command Reference Guide
To Next Page
Loading...
