F
Table
l-11.
HP-IB
Only
Commands
(continued)
Action
Mnemonic S ?
Description
lelect l-port
al
CAL1
:opy
defaull
DEFLTCPIO
:xternal
rigger
EX’ITHIGH
EXTI’LOW
ientify
IDN?
:ey
:ey
code
IOVC2
larker
IO
peration
tn
ompletion
lot/print
)ftkeys
KEY[D]
KOR?
MARKBUCK[D]
NOOP
DPC
PSOET<ONIOF’F>
Ii
1
1
1
1
1
1
1
3
1
1
>
AANEOUS
Provides access to functions within the l-port
cal menu. (HP 8610 compatibility.)
Sets up a default state for copy.
Sets the trigger polarity high.
Sets the trigger polarity low.
Outputs the identification string:
“HEWLE’lT
PACKARD,
87NNE,O,XXX”,
where
87NNE
is
the model number of the instrument and XXX
is the firmware revision of the instrument.
Imitates pressing a key. The data transmitted is
the key code, as defined in Figure 1-6. Range
for D- 1 to 61.
3utputa last key code or knob count. If the
reply is positive, it is a key code. If it is
negative, then set bit 16 equal to bit 14, and
ths
resulting two byte integer is the RPG knob
zount. It can be either positive or negative.
There
are about 120 counts per turn.
Moves the marker to the selected point on the
trace. On a 201 point sweep, D can range from
1
to 200.
Creates
a cycle that has no operation. OPC
compatible.
Zauses
reporting of the last OPC-compatible
:ommand completion.
includes the softkey menu keys when printing
)r plotting the screen.
3
HP-IB Programming and Command Reference Guide
l-95
To Next Page
Loading...
