Note
The commands for array input and output require the
user to set the data format for transfers in and out of
the instrument. Refer to
‘fable
l-5
and the mnemonic
descriptions of FORMl,
FORMB,
FORM3,
FORM4,
and
FORM5.
OUTPACTI
Outputs the value of the active function, or the last
active function if the active entry area is OFF.
OUTPAMAX
Outputs the max values for all limit line segments.
OUTPAMIN
Outputs the min values for all limit line segments.
OUTPAPER
Outputs the smoothing aperture in stimulus units,
rather than as a percentage.
These 12 commands output an error correction array for the active
calibration on the active channel. See
‘fable
l-8, for the contents of
each array. Each array is output in the currently set form determined
by the
FORMn
command. The data is in real/imaginary pairs, the same
number of pairs as points in the sweep.
OUTPCALCOl
Array 1.
OUTPCALCOB
Array 2.
OUTPCALC03
Array 3.
OUTPCALCO4
Array 4.
OUTPCALC05
Array 5.
OUTPCALCOG
Array 6.
OUTPCALC07
Array 7.
OUTPCALCOS
Array 8.
OUTPCALCOS
Array 9.
OUTPCALClO
Array 10.
OUTPCALCll
Array 11.
OUTPCALCl2
Array 12.
OUTPCALK
Outputs the currently active calibration
kit, as a less than 1000 byte string. The
data is in FORM 1.
l-132
HP-IB
Progr
ammiug and Command Reference Guide
To Next Page
Loading...
