UP
Increments the value in the active entry
area (up key).
USEPASC
Puts the analyzer in pass control mode.
These commands select the sensor input being used with the HP
438A
power meter. For the HP
436A
or
437B,
the A sensor is always used:
USESENSA
Sensor A.
USESENSB
Sensor B (available with HP
438A
only).
VELQFACT[D]
Enters the velocity factor of the
transmission medium. Range:
0
to
10.
VIEM<ONJOFF>
Displays the measurement trace (ON) or
the mixer setup (OFF).
VOFF[D]
Sets the local oscillator frequency for
use in frequency offset mode. See also
LOFBEQ[D].
Range: flequenc~ range of
instrument.
WAIT
Waits for a clean sweep when used with
the OPC command.
WAVD
Selects waveguide electrical delay. (See
also COAD.)
WAVE
Specifies a waveguide standard while
defining a standard as part of a cal kit
modification, as opposed to coaxial.
WlDT<ONIOFF>
WIDV[D]
Turns the bandwidth search ON and OFF.
Enters the widths search parameter.
Range: amplitude range.
HP-IB
Progrm
‘ng and Command Reference Guide
l-161
To Next Page
Loading...
