HP 8753E - Page 60

Error
Number
Error
190 DISK MESSAGE LENGTH ERROR
I I
191 EXT SOURCE NOT READY FOR TRIGGER
I
192 FILE NOT FOUND
193 ASCII: MISSING ‘BEGIN’ statement
194 ASCII: MISSING ‘CITIFILE’ statement
195 ASCII: MISSING ‘DATA’ statement
196
ASCII: MISSING ‘VAR’ statement
197 FILE NOT FOUND OR WRONG TYPE
I I
198
NOT ALLOWED DURING POWER METER CAL
I
199
CANNOT MODIFY FACTORY PRESET
200
ALL REGISTERS HAVE BEEN USED
201 FUNCTION NOT VALID FOR INTERNAL MEMORY
202 FUNCTION NOT AVAILABLE
203
CANNOT READ/WRITE HFS FILE SYSTEM
204
FREQS CANNOT BE CHANGED, TOO MANY POINTS
205
LIMIT TABLE EMPTY
206 ARGUMENT OUT OF RANGE
207 POWER OUT MAY BE UNLEVELED
208
EXT R CHAN MUST BE ON FOR FREQUENCY OFFSET MODE
209
SWEEP MUST BE STEPPED FOR FREQUENCY OFFSET
MODE
211 OVERLAP! LIST TYPE CHANGED TO STEPPED
212
ANALOG BUS DISABLED IN 6 kHz IFBW
213
RANGE CAUSED POWER LVL CHANGE IN LIST
214
CORRECTION ON: AUX CHANNEL(S) RESTORED
215
I CAUTION: CORRECTION OFF: AUX CHANNEL(S) DISABLED I
216
CAUTION: AUX CHANNELS MEASURE S-PARAMETERS
ONLY
217
2-PORT CAL REQUIRED FOR AUX CHANNEL USE
HP-IB Programrm
‘ng and Command Reference Guide
l-53