Chapter 1 25
Installing Your Analyzer
STEP 5. Verify the Analyzer Operation
To Test the Reflection Mode
1. Connect the equipment as shown and
press Preset.
2. Look at the measurement trace displayed
on the analyzer. It should be similar to the
trace below.
3. To check the reverse reflection mode for
channel 1, press Meas, Refl: REV S22 (B/R). The
measurement trace should be similar to the
trace shown below.
4. If you are ready to start making
measurements, continue with the next
chapter "Quick Start: Learning How to
Make Measurements".
To Next Page
Loading...
