36 Chapter 2
Quick Start: Learning How to Make Measurements
Learning to Make Transmission Measurements
Step 3. Measure the device
1. Connect your test device as in Figure 2-2. Use adapters where appropriate.
2. Press
Scale Ref, AUTO SCALE to reposition the measurement trace for the best view.
3. Press
Marker and turn the front panel knob to place the marker at a frequency of interest.
Read the device's insertion loss to 0.001 dB resolution as shown in Figure 2-4.
The analyzer shows the frequency of the marker location in the active entry area
(upper-left corner of display). The analyzer also shows the amplitude and frequency of
the marker location in the top-right corner of the display.
Figure 2-4 Example Measurement of Insertion Loss
To Next Page
Loading...
