HP 8753E - To Configure the Analyzer with Printers or Plotters

Chapter 1 11
Installing Your Analyzer
STEP 4. Configure the Analyzer
To Configure the Analyzer with Printers or Plotters
1. Connect your printer or plotter to the corresponding interface.
2. If you are using the parallel interface, press Local and PARALLEL until your choice of
[GPIO] or [COPY] appears.
■ If you choose [COPY], the parallel
port is dedicated for normal copy
device use (printers or plotters).
■ If you choose [GPIO], the parallel
port is dedicated for general purpose
I/O. The HP 8753E controls the data
input or output, through the
sequencing capability of the
analyzer.