12 Chapter 1
Installing Your Analyzer
STEP 4. Configure the Analyzer
3. Press SET ADDRESSES and then choose either PRINTER PORT or PLOTTER PORT, depending on
your hardcopy device. Or, if you are plotting your files to disk, press SET ADDRESSES,
PLOTTER PORT, DISK. Enter the HP-IB address of the peripheral, followed by [x1].
4. Press HPIB and the key that corresponds to your printer or plotter interface: PARALLEL
(parallel port) or SERIAL (serial port). NOTE: The plotter menu is shown as an example. It
will only appear if you select PLOTTER PORT. Similar interface choices will appear if you
select PRINTER PORT.
■ If you select HPIB, the HP-IB address
is active so you can then set the
address of your printer or plotter.
■ If you have already selected the
PARALLEL [COPY] choice for the
parallel-port configuration, you
must also select
PARALLEL in this
menu in order to generate a
hardcopy.
To Next Page
Loading...
