Chapter 2 45
Quick Start: Learning How to Make Measurements
Learning to Make Reflection Measurements
Step 4. Output measurement results
This step in the procedure shows you how to output the measurement results to a printer.
For in-depth information on creating a hardcopy of the measurement results, refer to the
"Printing, Plotting, and Saving Measurement Results" chapter in the
HP 8753E Network Analyzer User's Guide.
1. Connect a printer to the analyzer as described in the "Installing Your Analyzer"
chapter.
2. Press
Display, MORE, TITLE and then create a title for the measurement, as shown in Figure
2-11:
■ Use an optional DIN keyboard to type the title, or
■ Use the front panel knob and the softkey menu to select each letter of the title.
3. Press
DONE when you finish creating the measurement title. The title appears on the
upper-left corner of the analyzer display.
4. Press Local, SYSTEM CONTROLLER to set up the analyzer as the controller. If you are using an
HP-IB printer, ensure that there is not another controller on the bus. (Note that this
step is not required when using parallel or serial printers.)
5. Press
Copy, PRINT MONOCHROME to create a black and white hardcopy.
NOTE If you encounter a problem when printing a hardcopy, refer to "To
Configure an Analyzer with Printers or Plotters" in the "Installing your
Analyzer" chapter.
Figure 2-11 Example Measurement Title
To Next Page
Loading...
