HP 8924C - Page 12

12
In this Book Throughout this manual the term "Test Set" is used to denote the HP 8924C.
Test Set screens shown in this manual may not match those displayed on the Test
Set in every detail.
Chapter 1, Getting Started
This chapter provides basic remote and front-panel operating procedures, a quick check
for verifying operation, HP-IB programming procedures, and simple programming
examples.
Chapter 2, Configuring Your Test Set
This chapter provides information about setting screen intensity, setting RF voltage
interpretation, setting time and date, and setting the beeper’s volume.
Chapter 3, Operating Overview
This chapter explains how to specify units of measure, how to use the analog meter,
how to use measurement averaging, how to set a measurement reference, how to set
measurement limits, how to enter and change values, how to save and recall instrument
setups, how to use the USER keys, and how to set a frequency offset. It also describes
some important interactions that occur between screen settings.
Chapter 4, Status Reporting
This chapter provides information about the Test Set’s status reporting structure and
status register groups.
Chapter 5, Remote Capabilities
This chapter describes the remote interface’s functions.
Chapter 6, Remote/Local Modes
This chapter describes the control annunciators, the effect of remote mode on front-
panel operation, the transitions from remote-to-local or local-to remote modes, and
how local lockout and clear lockout affect the Test Set’s operation.
Chapter 7, Memory Cards, Mass Storage
This chapter describes memory cards and mass storage devices used with the
Test Set.
Error Messages
This section discusses error and operating messages.