68
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
Setting an RF Generator/Analyzer Level Offset
Setting an RF Generator/Analyzer Level Offset
You can correct for path loss by setting up an RF Level Offset on the front-panel
RF connector(s) used in your application. At power-up and instrument preset this
feature is OFF with 0.0 dB loss in all connector fields.
An RF Level Offset is required to ensure proper power levels to the analyzer when
testing CDMA mobile stations.
Refer to “Determining and Correcting for RF Path Loss” in Calibrating the Test
Set chapter of the HP 8924C Application Guide.
To Next Page
Loading...
