49
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
To Change the Measurement Display
To Change the Measurement Display
Using the On/Off Function
The on/off function is used for the following operations.
• Measurements that are displayed as numbers, or as meters using the METER function,
can be turned on and off.
• The data functions REFerence, METer, HLIMit and LLIMit can be turned on and off.
• Any instrument function that generates a signal can be turned on and off. This includes
the CDMA Sector A Power, Sector B Power, and AWGN.
• Trace displays, such as the CDMA Reverse Channel Spectrum Analyzer, cannot be
turned off.
The front-panel ON/OFF key is used to turn measurements, instrument functions
and data functions on or off.
Front-Panel Example
The following front-panel operation turns Avg Power off.
1. Move the cursor in front of the unit-of-measure for the Avg Power measurement.
2. Press the ON/OFF key. The Avg Power measurement field displays the word OFF
in place of units
The HP-IB STATe command corresponds to the front-panel ON/OFF key. You
can use 1 in place of on, or 0 in place of off.
HP-IB Example
The following HP-IB command turns off the Avg Power measurement.
“DISP CCNT;MEAS:CDM:AVGP:STAT OFF”
To Next Page
Loading...
