HP 8924C - Addressing

36
S:\HP8924C\USRGUIDE\BOOK\chapters\getstart.fb
Chapter 1, Getting Started
Addressing
Addressing
Setting the Test Set Bus Address
The Test Set’s HP-IB bus address is set using the HP-IB Adrs field which is
located on the I/O CONFIGURE screen. The Test Set’s HP-IB address is set to
decimal 14 at the factory. To set a different HP-IB bus address; select the I/O
CONFIGURE screen and position the cursor next to the
HP-IB Adrs field. The
address can be set from decimal 0 to 30 using the numeric DATA keys, or by
pushing and then rotating the CURSOR CONTROL knob. There are no switches
for setting the HP-IB bus address in the Test Set. The new setting is retained when
the Test Set is turned off.
Displaying the Bus Address
The Test Set’s HP-IB bus address can be displayed by pressing and releasing the
SHIFT key, then the LOCAL key. The address is displayed in the upper-left
corner of the display.