79
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
Triggering CDMA Measurements In Local Mode (Front Panel Operation)
Triggering CDMA Measurements In Local Mode (Front Panel Operation)
1. Select the desired trigger mode.
For FER and Rho
Suite of
Measurements
• Continuous - Once a measurement has completed, the Test Set is internally re-
triggered and another measurement cycle begins.
• Single - Requires selection of the Arm field to be begin a measurement cycle.
Manual Operation:
1. Position the cursor at the Single/Cont field.
2. Press the knob to underline the desired mode.
When Single is selected, the Arm and Disarm fields are displayed. When Continuous is selected the
Arm and Disarm fields will not appear.
To Screen
CDMA CELLULAR MOBILE RECEIVER TEST
FER
Test Status
Display
Interim
Results
Yes/No
Max Frames
On/Off
Sector A
Power
-75.0
dBm/BW
%
Connected
Svc Opt 2
Testing
Passed
Failed
Max Frames
Errors Counted
Traffic
Data Mode
Svc Opt 1
Data Rate
Full
Eb/Nt
CDMA
CALL CNTL
Analog
RX TEST
Cnfig
PRNT CNFG
Frames Counted
Meas Cntl
Single/Cont
Arm
Disarm
Confidence
95.00
FER Specs
3.00
----
Traffic
15.6
dB
AWGN
-75.0
dbm/BW
%
%
To Next Page
Loading...
