HP 8924C - To Enter and Change Values

58
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
To Enter and Change Values
To Enter and Change Values
To Enter Decimal Values
Values can be entered and changed using various methods, depending on your
testing needs. The unit-of-measure for some of these fields can also be changed
(
see "To Specify Units-of-Measure for HP-IB Data Transfer" on page 56).
1. Position the cursor in front of the numeric entry field to be changed.
2. Either:
• Enter the number and unit-of-measure directly using the keypad, or
• Press the CURSOR CONTROL knob or the ENTER key to highlight the field, and
use the knob, or
• Use the down-arrow and up-arrow keys to increment or decrement the present val-
ue.
Front-Panel Example
The following front panel operation changes Sector A Power to -73 dBm/BW.
1. Move the cursor in front of the Sector A Power field.
2.
Enter −73 dBm using the DATA keys.
HP-IB Example
The following HP-IB command also changes Sector A Power to
−73 dBm/BW.
“DISP CCNT;CDMA:CELL:ASEC -73 DBM;ASEC:STAT ON”