76
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
Triggering Analog Measurements In Local Mode (Front Panel Operation)
Triggering Analog Measurements In Local Mode (Front Panel Operation)
1. Select the desired trigger mode.
For Signaling
Decoder
• Continuous - Once a measurement has completed, the Test Set is internally re-
triggered and another measurement cycle begins.
• Single - Requires selection of the Arm Meas field to be begin a measurement cycle.
Manual Operation:
1. Position the cursor at the Single/Cont field.
2. Press the knob to underline the desired mode.
Single/Cont
Arm
SIGNALING DECODER
To Next Page
Loading...
