44
S:\HP8924C\USRGUIDE\BOOK\chapters\configts.fb
Chapter 2, Configuring Your Test Set
General Operating Information
General Operating Information
The following configuration information discusses general operating information
for some of the fields in the CONFIGURE screen.
To Set Screen Intensity
1. Access the CONFIGURE screen.
2. Select the Intensity field.
3. Rotate the knob to change the setting (1=dim, 8=bright).
To Set RF Voltage Interpretation (50 ohm/emf)
1. Access the CONFIGURE screen.
2. Position the cursor in front of the RFGen Volts field.
3. Press the CURSOR CONTROL knob or press the ENTER key to select 50 ohm
or
emf
.
Voltage settings can control either:
• the voltage across a 50-ohm load, or
• the open circuit voltage (emf).
This setting affects the RF Generator and Tracking Generator amplitudes.
To Next Page
Loading...
