45
S:\HP8924C\USRGUIDE\BOOK\chapters\configts.fb
Chapter 2, Configuring Your Test Set
General Operating Information
To Set the Date and Time
1. Access the CONFIGURE screen.
2. Select the Date field and use the DATA keys to enter the date in the format shown
below the field.
3. Select the Time field and use the DATA keys to enter the time in the format shown
below the field.
The Test Set has a built-in clock that keeps track of the date and time. It is
powered by an internal battery to keep it operating when the instrument is off.
To Change the Beeper’s Volume
1. Access the CONFIGURE screen.
2. Select the Beeper field to display the volume choices.
3. Select the desired choice.
The beeper alerts you to important operating and measurement conditions. It
beeps any time a message is displayed at the top of the screen. These messages
warn you of conditions such as exceeding the RF input level or trying to set a field
to an unacceptable value. Therefore, it is recommended that you do not disable the
beeper.
To Next Page
Loading...
