78
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
Triggering Analog Measurements In Local Mode (Front Panel Operation)
2. Trigger the Signaling Decoder (applies if trigger mode is "Single")
Manual Operation:
1. Position the cursor at the Arm Meas field.
2. Press the knob.
Arming the Signaling Decoder as shown in this example will cause the measurement to be automati-
cally triggered by an internal trigger command.
Selecting the Stop Meas field will stop the currently executing measurement cycle for the Signaling
Decoder.
Single/Cont
Arm Meas
SIGNALING DECODER
To Next Page
Loading...
