HP 8924C - Page 153

153
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Communication Status Register Group
The Communication Status Register Group contains information about the Test
Set’s hardware, and the summary message bits for the Serial 1 and Serial 2 Status
Register Groups.
The Status Byte Register summary message associated with the Communication
Status Register Group is bit zero. The Communication Status Register Group
SMB must be enabled in the Hardware1 Status Register Group before any of the
following events or conditions can be reported through the Status Byte Register.
Figure 18 shows the structure and STATus commands for the Communication
Status Register Group.
Table 11 shows the Communication Status Register Group Condition Register bit
assignments.