162
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Table 12 Hardware 1 Status Register Group Bit Assignments
Bit
Number
Is Condition
Register
Implemented?
Condition/Event Comment
15 Not used in Test Set Defined by SCPI Version 1994.0
14 YES Radio Interface Board inter-
rupt 2 tripped
13 YES Radio Interface Board inter-
rupt 1 tripped
12 YES Signaling Decoder Measure-
ment Results Available
11 YES Signaling Decoder Input Level
Too Low
10 YES Signaling Decoder is Measur-
ing
9 YES Signaling Decoder is Armed
8 YES Signaling Encoder Sending
Auxiliary Information
If the Signaling Mode selected has two
information fields, such as the AMPS Filler
and Message fields, and both fields are
being sent, this bit will be set.
7 YES Signaling Encoder Sending
Information
If the Signaling Mode selected has only one
information field and the field is being sent,
this bit will be set high. If the Signaling
Mode selected has two information fields,
such as the AMPS Filler and Message
fields, and only one field is being sent, this
bit will be set high.This bit is not active if
the Signaling Encoder Mode is set to Func-
tion Generator
6 YES Communication Status Regis-
ter Group SMB
5 NO Measurement Limit(s)
exceeded
This bit is set high if the Measurement High
Limit or Low Limit is exceeded
4 YES Power-up Self Test(s) Failed
3 YES Overpower Protection Tripped
To Next Page
Loading...
