171
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Measuring Status Register Group
The Measuring Status Register Group contains information about measurements
performed by the Test Set.
The Status Byte Register summary message associated with the Measuring Status
Register Group is bit seven. The Measuring Status Register SMB must be enabled
in the Operation Status Register Group before any of the
events or conditions can be reported through the Status Byte Register.
Figure 22 shows the structure and STATus commands for the Measuring Status
Register Group.
Table 14 shows the Measuring Status Register Group bit assignments.
To Next Page
Loading...
