HP 8924C - Page 184

184
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Table 16 Questionable Data/Signal Register Group Bit Assignments
Bit
Number
Is Condition
Register
Implemented?
Condition/Event Comment
15 Not Used (Always 0) Defined by SCPI Version 1994.0
14 YES Command Warning 1 = A command has ignored a parameter
during execution.
13 Unused in Test Set
12 Unused in Test Set
11 Unused in Test Set
10 Unused in Test Set
9 Unused in Test Set
8 YES Calibration Register Group
Summary Message
1 = one or more of the enabled events
have occurred since the last reading or
clearing of the Event Register
7 Unused in Test Set
6 Unused in Test Set
5 Unused in Test Set
4 Unused in Test Set
3 Unused in Test Set
2 Unused in Test Set
1 Unused in Test Set
0 Unused in Test Set