255
S:\HP8924C\USRGUIDE\BOOK\CHAPTERS\ibasic.fb
Chapter 6, IBASIC Controller
Interfacing to the IBASIC Controller using Serial Ports
d. Select Communications (the first five of the following Communications
choices for your PC Serial Port should match your Test Set settings).
1. Baud Rate: 9600
2. Data Bits: 8
3. Stop Bits: 1
4. Parity: None
5. Flow Control: Xon/Xoff
6. Connector: COM1, COM2, COM3, or COM4 depending on your PC
setup
7. Parity Check: Off
8. Carrier Detect: Off
To Next Page
Loading...
