286
S:\HP8924C\USRGUIDE\BOOK\CHAPTERS\ibasic.fb
Chapter 6, IBASIC Controller
PROGram Subsystem
Test Set PROGram Subsystem
The Test Set was designed to store only one IBASIC program in RAM memory at
any given time. The PROGram Subsystem commands, as implemented in the Test
Set, operate differently than described in the SCPI Standard. In addition, the SCPI
PROGram Subsystem commands which were designed to support multiple
programs are not supported in the Test Set.
Supported SCPI Commands
The Test Set supports the following subset of the :SELected SCPI commands.
• :SELected:DEFine
• :SELected:DEFine?
• :SELected:DELete:ALL
• :SELected:EXECute
• :SELected:NUMBer
• :SELected:NUMBer?
• :SELected:STATe
• :SELected:STATe?
• :SELected:STRing
• :SELected:STRing?
• :SELected:WAIT
Unsupported SCPI Commands
The Test Set does not support the following SCPI commands.
•:CATalog?
• :SELected:DELete:SELected
• :SELected:MALLocate
• :SELected:MALLocate?
• :SELected:NAME
• :SELected:NAME?
• :EXPLicit:DEFine
• :EXPLicit:DEFine?
• :EXPLicit:DELete
• :EXPLicit:EXECute
• :EXPLicit:MALLocate
• :EXPLicit:MALLocate?
• :EXPLicit:NUMBer
• :EXPLicit:NUMBer?
• :EXPLicit:STATe
• :EXPLicit:STATe?
• :EXPLicit:STRing
• :EXPLicit:STRing?
• :EXPLicit:WAIT
To Next Page
Loading...
