HP 8924C - Page 310

310
S:\HP8924C\USRGUIDE\BOOK\CHAPTERS\ibasic.fb
Chapter 6, IBASIC Controller
The TESTS Subsystem
TESTS Subsystem User-Interface Screens
The TESTS Subsystem allows the user to easily modify the test subroutines,
parameters, specifications and configuration to correspond to the requirements of
a specific radio. There are several user-interface screens provided to allow the
user to make modifications.
To access any of these screens, position the cursor on the desired field and push
the rotary knob.
•The Order of Tests screen lets the user select the desired test(s) from the full set of avail-
able tests in the loaded procedure file.
•The Channel Information screen defines the transmit and receive frequencies used for
the selected tests.
•The Pass/Fail Limits screen defines the specifications used to generate pass/fail mes-
sages during testing.
•The Test Parameters screen is used to define instrument settings and characteristics to
match those of the radio being tested (audio load impedance, audio power, power sup-
ply voltage, etc.).
•The External Devices screen identifies all connected HP-IB equipped instruments and
their HP-IB addresses.
•The Save/Delete Procedure screen is used to save or delete Procedures.
•The Printer Setup screen is used to select the printer used for IBASIC PRINT com-
mands and to configure the format of the printer page.
•The Execution Cond screen is used to configure the IBASIC program execution condi-
tions.
•The IBASIC Cntrl screen is the IBASIC Controllers display screen.
Refer to the TESTS Screen chapter for descriptions in the HP 8924C Reference
Guide for information concerning how the different TESTS Subsystem screens
are used.
The use of the IBASIC Controller screen is described in the beginning of this
chapter.