328
S:\HP8924C\USRGUIDE\BOOK\CHAPTERS\errorms.fb
Chapter , Error Messages
Error −215 Arm deadlock
Indicates that the arm source for the initiation of a measurement is set to GET and
subsequent measurement query is received. The measurement cannot be started until a
GET is received, but the GET would cause an INTERRUPTED error.
Error −220 Parameter error
Indicates that a program data element related error occurred.
Error −221 Settings conflict
Indicates that a legal program data element was parsed but could not be executed due to
the current device state (see IEEE 488.2, 6.4.5.3 and 11.5.1.1.5).
Error −222 Data out of range
Indicates that a legal program data element was parsed but could not be executed because
the interpreted value was outside the legal range as defined by the device (see IEEE 488.2,
11.5.1.1.5).
Error −223 Too much data
Indicates that a legal program data element of block, expression, or string type was
received that contained more data than the device could handle due to memory or related
device- specific requirements.
Error −224 Illegal parameter value
Used where exact value, from a list of possibles, was expected.
Error −230 Data corrupt or stale
Possibly invalid data; new reading started but not completed since last access.
Error −231 Data questionable
Indicates that measurement accuracy is suspect.
Error −240 Hardware error
Indicates that a legal program command or query could not be executed because of a
hardware problem in the device.
To Next Page
