332
S:\HP8924C\USRGUIDE\BOOK\CHAPTERS\errorms.fb
Chapter , Error Messages
Error −284 Program currently running
Certain operations dealing with programs are illegal while the program is running. For
example, deleting a running program is not possible.
Error −285 Program syntax error
Indicates that syntax error appears in a downloaded program.
Error −286 Program runtime error
Error −300 Device-specific error
This code indicates only that a Device-Dependent Error as defined in IEEE 488.2,
11.5.1.1.6 has occurred.
Error −310 System error
Indicates that some error, termed “system error” by the device, has occurred.
Error −311 Memory error
Indicates that an error was detected in the device’s memory.
Error −312 PUD memory lost
Indicates that the protected user data saved by the *PUD command has been lost.
Error −313 Calibration memory lost
Indicates that nonvolatile calibration data used by the *CAL? command has been lost.
Error −314 Save/recall memory lost
Indicates that the nonvolatile data saved by the *SAV command has been lost.
Error −315 Configuration memory lost
Indicates that nonvolatile configuration data saved by the device has been lost.
To Next Page
