334
S:\HP8924C\USRGUIDE\BOOK\CHAPTERS\errorms.fb
Chapter , Error Messages
Error −440 Query UNTERMINATED after indefinite response
Indicates that a query was received in the same program message after a query requesting
an indefinite response was executed (see IEEE 488.2, 6.5.7.5.7).
Error −606 Update of Input Module Relay Switch Count file failed.
Indicates that the Test Set was not able to update the Input Module Relay Switch Count
EEPROM file with the current switch count data from the non-volatile RAM switch count
array. This error is most probably generated as a result of a hardware error or failure.
Refer to the HP 8924C Assembly Level Repair Manual for diagnostic information.
Error −607 Checksum of Non-Volatile RAM Relay Count data bad.
Indicates that the Test Set was not able to generate the proper checksum for the Input
Module Relay Switch Count data from the non-volatile RAM switch count array. This
error is most probably generated as a result of a hardware error or failure. Refer to the
HP 8924C Assembly Level Repair Manual for diagnostic information.
Error −608 Initialization of Input Module Relay Count file failed.
Indicates that the Test Set was not able to initialize the Input Module Relay Switch Count
EEPROM file during installation of a new input module. This error is most probably
generated as a result of a hardware error or failure. Refer to the HP 8924C Assembly Level
Repair Manual for diagnostic information.
Error −1300 Order attempted while not in Connect state.
Indicates that an attempt was made to send an order type Mobile Station Control Message
(that is - order a change in power level, put the mobile station in maintenance mode, or
send an alert message to the mobile station) when the Call Processing Subsystem was not
in the Connect state.
Error −1301 Handoff attempted while not in Connect state.
Indicates that an attempt was made to handoff a mobile station to a new voice channel
when the Call Processing Subsystem was not in the Connect state.
Error −1302 Release attempted while not in Connect state.
Indicates that an attempt was made to send a Release message to a mobile station when the
Call Processing Subsystem was not in the Connect state.
To Next Page
Loading...
