HP 8924C - Page 81

81
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
Triggering CDMA Measurements In Local Mode (Front Panel Operation)
2. Trigger the FER and Rho Suite Measurements (applies if trigger mode is "Single")
Manual Operation:
1. Position the cursor at the Arm field.
2. Press the knob.
Arming the FER measurement as shown in this example will cause the measurement to be triggered
by an internal trigger event. The Rho suite of measurements operate similarly.
Selecting the Disarm field will stop the currently executing measurement cycle for the FER or Rho
Suite of Measurements.
To Screen
CDMA CELLULAR MOBILE RECEIVER TEST
FER
Test Status
Display
Interim
Results
Yes/No
Max Frames
On/Off
Sector A
Power
-75.0
dBm/BW
%
Connected
Svc Opt 2
Testing
Passed
Failed
Max Frames
Errors Counted
Traffic
Data Mode
Svc Opt 1
Data Rate
Full
Eb/Nt
CDMA
CALL CNTL
Analog
RX TEST
Cnfig
PRNT CNFG
Frames Counted
Meas Cntl
Single/Cont
Arm
Disarm
Confidence
95.00
FER Specs
3.00
----
Traffic
15.6
dB
AWGN
-75.0
dbm/BW
%
%