HP 8924C - Page 91

91
S:\HP8924C\USRGUIDE\BOOK\chapters\opoverv.fb
Chapter 3, Operating Overview
Increasing Measurement Throughput
The following example...
• 10 OUTPUT 714;"CDMA:CELL:ASECTOR:BWPOWER -70 DBM", and
•
20 OUTPUT 714;"CDMA:CALL:MAKE"
could be replaced with:
OUTPUT 714;"CDMA:CELL:ASECTOR:BWPOWER -70 DBM;:CDMA:CALL:MAKE"
Reading multiple values using one ENTER statement
The following two lines of code query the Test Set for an Average Power
measurement and the Average Power HP-IB units, then read both of these
values into the two variables Average_power and Units$.
The following example...
• 10 OUTPUT 714;"MEAS:CDMANALYZER:AVGPOWER?",
• 20 ENTER 714;Average_power
• 30 OUTPUT 714;"MEAS:CDMANALYZER:AVGPOWER:UNITS?",
• 40 ENTER 714;Units$
could be replaced by:
10 OUTPUT 714;"MEAS:CDMANALYZER:AVGPOWER?;AVGPOWER:UNITS?"
20 ENTER 714;Average_power,Units$