Parameters
interval: Ethernet OAM connection timeout timer, in milliseconds. The value of this argument must be a
multiple of 100, it ranges from 1000 to 25000.
Description
Use the oam timer keepalive command to configure the Ethernet OAM connection timeout timer.
Use the undo oam timer keepalive command to restore the default.
By default, the Ethernet OAM connection timeout timer is 5000 milliseconds.
After the timeout timer for an Ethernet OAM connection expires, the local OAM entity ages out its
connection with the peer OAM entity, causing the OAM connection to be disconnected. HP recommends
that you set the connection timeout timer at least five times the handshake packet transmission interval,
ensuring the stability of Ethernet OAM connections.
Related commands: oam timer hello and display oam configuration.
Examples
# Set the Ethernet OAM connection timeout timer to 2500 milliseconds—assume that the Ethernet OAM
handshake packet transmission interval is 500 milliseconds.
<Sysname> system-view
[Sysname] oam timer keepalive 2500
reset oam
Syntax
reset oam [ interface interface-type interface-number ]
View
User view
Default level
2: System level
Parameters
interface interface-type interface-number: Specifies a port by its type and number.
Description
Use the reset oam command to clear the statistics on Ethernet OAM packets and Ethernet OAM link error
events of an Ethernet port.
If you do not specify the interface keyword, this command clears the statistics on the Ethernet OAM
packets and the Ethernet OAM link error events of all the ports.
Related commands: display oam and display oam link-event.
Examples
# Clear the statistics on Ethernet OAM packets and Ethernet OAM link error events of all the ports.
<Sysname> reset oam
19
To Next Page
Loading...
Need help?
General
