HP A3100-8 v2 SI - Smart-Link Group

Examples
# Enable Ethernet 1/0/1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] smart-link flush enable
# Enable Layer 2 aggregate interface 1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] smart-link flush enable
smart-link group
Syntax
smart-link group group-id
undo smart-link group group-id
View
System view
Default level
2: System level
Parameters
group-id: Smart link group ID, in the range of 1 to 24.
Description
Use the smart-link group command to create a smart link group and enter smart link group view.
Use the undo smart-link group command to remove a smart link group.
A smart link group with member ports cannot be removed.
Examples
# Create smart link group 1 and enter smart link group view.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1]
37