reset smart-link statistics
Syntax
reset smart-link statistics
View
User view
Default level
2: System level
Parameters
None
Description
Use the reset smart-link statistics command to clear the statistics about flush messages.
Examples
# Clear the statistics about flush messages.
<Sysname> reset smart-link statistics
smart-link flush enable
Syntax
smart-link flush enable [ control-vlan vlan-id-list ]
undo smart-link flush enable [ control-vlan vlan-id-list ]
View
Layer 2 Ethernet port view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
control-vlan vlan-id-list: Specifies the control VLANs used for receiving flush messages. The vlan-id-list is
expressed in the form of vlan-id-list = { vlan-id [ to vlan-id ] }&<1-10>, where the vlan-id argument
represents the ID of a control VLAN which ranges from 1 to 4094. &<1-10> indicates that you can
provide up to ten VLAN IDs or VLAN ID lists.
Description
Use the smart-link flush enable command to configure a receive control VLAN (a VLAN for receiving
flush messages).
Use the undo smart-link flush enable command to disable flush message processing.
By default, flush messages are not processed.
If no VLAN is specified, VLAN 1 applies.
This command cannot be used on member port of an aggregation group.
Related commands: flush enable.
36
To Next Page
Loading...
Need help?
General
