85
9
Adapting to Cabling Systems
This chapter provides information for using a HP DTC unit with the following
cabling systems:
• ATT356A
• 10BaseT
• ATT258A
A DTC unit can be linked to devices, such as terminals or printers, using any of the
cabling systems listed above. To do this, the DTC can be connected to the cabling
system via cross-connect blocks or via an RJ45 patch panel.
On the following pages you will find detailed tables, describing the cross-connect
block connections for each of these cabling systems. Information is also provided
for the connection to these cabling systems via RJ45 patch panels.
To Next Page
Loading...
Need help?
General