HP A5120 EI - Page 71

66
Specifying a transit node
Perform this configuration on a device to be configured as a transit node.
Follow these steps to specify a transit node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—
Specify the current device as a
transit node of the ring, and
specify the primary port and the
secondary port
ring ring-id node-mode transit [
primary-port interface-type
interface-number ] [ secondary-
port interface-type interface-
number ] level level-value
Required
Specifying an edge node
When configuring an edge node, you must first configure the primary ring before configuring the
subrings.
Perform this configuration on a device to be configured as an edge node.
Follow these steps to specify an edge node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—
Specify the current device as a
transit node of the primary ring,
and specify the primary port and
the secondary port
ring ring-id node-mode transit [
primary-port interface-type
interface-number ] [ secondary-
port interface-type interface-
number ] level level-value
Required
Specify the current device as the
edge node of a subring, and
specify the edge port
ring ring-id node-mode edge [
edge-port interface-type interface-
number ]
Required
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before configuring the
subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
Follow these steps to specify an assistant-edge node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—
Specify the current device as a
transit node of the primary ring,
and specify the primary port and
the secondary port
ring ring-id node-mode transit [
primary-port interface-type
interface-number ] [ secondary-
port interface-type interface-
number ] level level-value
Required