HP A7510 User Manual

21
Follow these steps to modify a member ID for a member switch:
To do… Use the command…
Remarks
Enter system view system-view —
Modify a member ID for a
member switch
irf member member-id renumber
new-member-id
Optional
The switch has no default ID in
standalone mode. After it
switches to the IRF mode, it uses
the member ID pre-configured in
standalone mode by default.
CAUTION:
• Member ID changes take effect at the reboot of the switch.
• Change member IDs for the switches in an IRF fabric with caution. The change might cause
configuration change and even data loss.
• Different switch models and cards have different requirements for member IDs. See “Setting a member
ID
for the switch.”
Specifying a priority for a member switch
Follow these steps to specify a priority for a member switch:
To do… Use the command…
Remarks
Enter system view system-view —
Specify a priority for a member of
an IRF fabric
irf member member-id priority priority
Optional
The priority of a member defaults
to 1.
Configuring IRF ports
After an IRF fabric is formed, you can add physical ports used to connect member switches.
Follow these steps to configure IRF ports:
To do… Use the command…
Remarks
Enter system view system-view —
Enter physical IRF port view
interface interface-type
interface-number
—
Shut down the port shutdown Required
Return to system view quit —
Create an IRF port and enter IRF
port view
irf-port member-id/port-number —

HP A7510 Specifications

General

Brand	HP
Model	A7510
Category	Switch
Language	English