HP A7510 User Manual

15
Task
Enabling automatic system software updating
Setting the IRF link down report delay
Configuring MAD detection
IRF configuration fast recovery
Pre-configuring an IRF member switch in standalone
mode
You can configure the IRF ports, member ID, and member priority for the switch when it is operating in
standalone mode. These configurations take effect when the operating mode of the switch changes to
IRF.
Setting a member ID for the switch
• A switch by default operates in standalone mode without an IRF member ID. You must assign it an
IRF member ID before you can set it in IRF mode. You can execute the display irf configuration
command and check the MemberID field. If the switch has no IRF member ID, the field displays two
hyphens (--).
• To avoid member ID collision with other members when the switch is added into an IRF fabric, plan
the member ID of this device when it operates in standalone mode.
Follow these steps to set a member ID for the switch:
To do… Use the command…
Remarks
Enter system view system-view —
Set a member ID for the switch
when it operates in standalone
mode
irf member member-id
Required
By default, no member ID is set
for the switch.
NOTE:
• The member ID of an A7510 switch can only be 1 or 3.
• The member ID of a switch installed with an LSQ1SRP1CB card can only be 1 or 2.
• For an A7506 or A7506-V switch using the member ID 4, if it runs a release prior to Release 6635, the
last two slots cannot be used; if it runs Release 6635 or later, the last slot cannot be used.
Specifying a priority for the switch
Follow these steps to specify a priority for the switch:
To do… Use the
command… Remarks
Enter system view system-view —
Specify a priority for the switch
when it operates in standalone
mode
irf priority priority
Optional
The priority of the switch defaults
to 1.

HP A7510 Specifications

General

Brand	HP
Model	A7510
Category	Switch
Language	English