Example: Using the
SET Command
This example uses the SET command to create a desired
state before sending a PostScript job. The SET command is
used only to set those features that affect the printed
output and that cannot be set using the desired personality.
After the job has been sent, the RESET command is issued
to return all features to their default values.
<ESC>%-12345X@PJL <CR><LF>
@PJL COMMENT Setting PostScript Job <CR><LF>
@PJL COMMENT to Desired State <CR><LF>
@PJL SET RET = MEDIUM <CR><LF>
@PJL SET PAGEPROTECT = OFF <CR><LF>
@PJL SET RESOLUTION = 600 <CR><LF>
@PJL ENTER LANGUAGE = POSTSCRIPT <CR><LF>
%!PS-ADOBE ... PostScript print job — use
~POSTSCRIPT code to set all values that are
~not set using PJL... ^D
<ESC>%-12345X@PJL <CR><LF>
@PJL RESET <CR><LF>
<ESC>%-12345X
Related Commands: DEFAULT, INITIALIZE, RESET, JOB, EOJ
Environment Commands 6-45
To Next Page
Loading...
