HP Color laserjet 5500 - Page 130

FILESYS Category The INFO FILESYS command returns the following
information for each volume intialized on the PJL file
system:
■ Total capacity ■ Volume label
■ Free space ■ Volume read/write status
■ Location
Example: Using the
INFO FILESYS
Command
<ESC>%-12345X@PJL <CR><LF>
@PJL COMMENT Using @PJL INFO FILESYS <CR><LF>
@PJL ECHO 11:33:42.3 9-20-96 <CR><LF>
@PJL INFO FILESYS <CR><LF>
<ESC>%-12345X
A sample HP LaserJet 5 printer response for this example
is shown below. Other printers may respond differently.
If the mass storage device is not present (but the file
system firmware is), or if there are not initialized volumes,
the reply will be as follows:
A printer with no file system firmware will treat this
command as a PJL INFO command with an unknown
category and will respond with the reply:
@PJL INFO FILESYS<CR><LF>
"?"<CR><LF>
<FF>
@PJL INFO FILESYS [2 TABLE]
VOLUME TOTAL SIZE FREE SPACE LOCATION LABEL STATUS<CR><LF>
0: 1755136 1718272 <HT> <HT> READ-WRITE<CR><LF>
@PJL INFO FILESYS [1 TABLE]
VOLUME TOTAL SIZE FREE SPACE LOCATION LABEL STATUS<CR><LF>
<FF>
7-22 Status Readback Commands