For example, in the following two sample PJL commands,
START is a valid option for the JOB command, but FINISH
is not a valid option (the END option should be used). The
START option is executed, but the FINISH option is
ignored.
Valid command:
@PJL JOB START = 1 <LF>
Invalid command:
@PJL JOB START = 1 FINISH = HOME <LF>
Note Any errors that occur during PJL parsing can be received
by enabling device status as described in Chapter 7 (send
the @PJL USTATUS DEVICE = VERBOSE command).
Appendix D lists the status codes that are received by the
host when an invalid command is received and unsolicited
verbose device status is enabled.
2-10 PJL Command Syntax and Format
To Next Page
Loading...
