General PJL Environment Variables
Variable Description Sample Value
Range
PRINTAREA INKEDAREA sets the DesignJet to shift the
plot to the top/left and advance the page cut in
order to save media.
FULLSIZE,
INKEDAREA
PRINTQUALITY Sets the default print quality for the current
PJL job.
DRAFT,
NORMAL, HIGH
QTY Sets the number of collated copies of a job. 1 to 999
RENDERMODE Sets the render mode for the personality. COLOR,
GRAYSCALE
REPRINT Determines whether pages are reprinted after
a paper jam. When AUTO is selected and the
amount of RAM installed is below a printer-
specific threshold, pages are not reprinted
after a jam. If the amount of RAM installed is
more than this threshold, the pages are
reprinted. The ON setting causes the printer to
reprint the job after a paper jam. The OFF
setting disables reprinting.
AUTO, OFF, ON
RESOLUTION Print resolution in dots per inch. When a job is
sent, if there is not enough memory to run
with the current resolution and page
protection configuration, the system
temporarily overrides the resolution and/or
page-protect values to run the job. When the
resolution is changed, memory is reconfigured
and all downloaded fonts, PCL macros, and
PostScript dictionaries are lost (however, no
I/O data is lost). Refer to “Commands that
Affect Printer Memory” in Appendix A.
300, 600
RESOURCESAVE Sets the value of the resource-saving variable. ON, OFF, AUTO
RESOURCE-
SAVESIZE
(This variable is set as a personality-specific
variable using LPARM : personality.) Sets the
size of the resource saving area for the
specified personality if RESOURCESAVE=ON.
0 to maximum
available memory
(in 100 Kbyte
increments)
6-20 Environment Commands
To Next Page
Loading...
