HP cr0970nd - Fan

3. Remove the speakers from the computer (3) .
Reverse this procedure to install the speakers.
Fan
To remove the fan, use this procedure and illustration.
Table 5-7
Fan description and part number
Description Spare part number
Fan assembly (left) for use in models with discrete graphics N18726-001
Fan assembly (right) for use in models with discrete graphics N18727-001
Fan assembly (left) for use in models with UMA graphics N13561-001
Fan assembly (right) for use in models with UMA graphics N13562-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 33).
2. Remove the bottom cover (see Bottom cover on page 33).
3. Remove the battery (see Battery on page 34).
Remove the fan assembly:
1. Disconnect the fan cables from the system board (1), and then disconnect the display panel cable (2)
from the system board.
2. Release the display panel cable from the fan's retention clips (3).
42
Chapter 5Removal and replacement procedures for authorized service provider parts