Need help?Do you have a question about the HP DL360 and is the answer not in the manual?
General| Processor Sockets | 2 |
|---|---|
| CPU | Intel Xeon Scalable |
| Memory | Up to 3TB DDR4 |
| Form Factor | 1U Rack |
| Power Supply | Redundant Power Supplies, various wattage options |
| Network Controller | Embedded 1Gb or 10Gb Ethernet |
| RAID Support | Smart Array RAID |
| Operating System Support | Windows Server, Linux, VMware |
| Storage | Up to 10 SFF SAS/SATA/NVMe drives or 4 LFF SAS/SATA drives |
Identifies and describes the components located on the front panel of the server.
Details the LEDs and buttons on the server's front panel and their status indicators.
Identifies and describes the components located on the rear panel of the server.
Details the LEDs and buttons on the server's rear panel and their status indicators.
Identifies and describes the various components located on the server's system board.
Instructions on how to power on the server using the Power On/Standby button.
Detailed steps for safely powering down the server, including warnings.
Steps to safely remove the server's access panel, including warnings.
Specifies clearances and airflow needs for proper server operation in a rack.
Information on electrical regulations and power supply requirements for the server.
Guidelines and standards for properly grounding the server.
General guidance for installing various hardware options in the server.
Detailed steps for installing the server into a rack, including safety.
Instructions for powering up the server and initial configuration.
Guidance on installing supported operating systems on the server.
Step-by-step guide for installing processor and fan modules.
Information about memory types, speeds, and compatibility for the server.
Details supported Advanced Memory Protection (AMP) modes for server memory.
General rules for populating DIMM slots across all AMP modes.
Step-by-step instructions for installing a DIMM into the server's memory slot.
General guidelines for adding SAS and SATA hard drives to the server.
Steps for safely removing a hot-plug SAS hard drive.
Instructions for installing a SAS hard drive into the server.
Information on the integrated Smart Array controller and upgrade options.
Overview of installing expansion boards like PCIe and PCI-X.
Detailed steps for installing a PCIe expansion board.
Information on installing redundant hot-plug power supplies and compatibility.
Overview of installing and enabling the Trusted Platform Module (TPM).
Step-by-step instructions for installing the TPM board onto the system board.
Instructions on how to enable the TPM through RBSU and the OS.
Information about the SmartStart software for server deployment and configuration.
Information on the ROM-Based Setup Utility (RBSU) for server configuration.
Explains how to configure Advanced Memory Protection (AMP) modes via RBSU.
Overview of the Array Configuration Utility (ACU) features.
Overview of the iLO 2 subsystem for remote server management.
Details on HP SIM for web-based server administration and management.
Proactive server management tool for diagnostics and troubleshooting.
Tools for secure remote support and problem solving.
Lists resources and guides for resolving common server problems.
Familiarize with safety information before troubleshooting the server.
Steps to prepare the server for effective diagnosis.
The initial flowchart to begin the server diagnostic process.
A generic troubleshooting flowchart for general or uncategorized problems.
Flowchart specifically for diagnosing server power-on issues.
Flowchart for troubleshooting issues where the server does not complete POST.
Flowchart for diagnosing problems related to the server's operating system boot process.
Flowchart for diagnosing server faults indicated by LEDs or management agents.
To Next Page