6–18 415606-001 Service Reference Guide, dx2200 MT
Removal and Replacement Procedures— Microtower (MT) Chassis
6.9.1 Power Switch Assembly
1. Prepare the computer for disassembly (Section 6.1, “Preparation for Disassembly”).
2. Remove the access panel and rotate the computer so the system board is parallel to the table
to make it easier to work on (Section 6.2, “Access Panel”).
3. Disconnect the braided Power/LED cables from the system board.
4. Free the braided cables from the cable tie that is attached to the chassis.
5. Squeeze the top of the switch holder 1. rotate the switch, and remove it from the chassis.
To install the power switch assembly, reverse the removal procedures.
To Next Page
Loading...
