HP E243d User Manual

24
computer’s on-board video sources.
Image appears blurred,
indistinct, or too dark.
Brightness setting is too low. Open the OSD menu, and select Brightness to adjust the brightness
scale as needed.
“Check Video Cable” is
displayed on the
screen.
Monitor video cable is disconnected. Connect the appropriate video signal cable between the
computer and monitor. Be sure that the computer power is off
while connecting the video cable.
“Input Signal Out of
Range” is displayed on
screen.
Video resolution and/or refresh rate
are set higher than the monitor
supports.
Change the settings to a supported setting.
The monitor does not
enter into a low-power
sleep state.
The monitor's power saving control is
disabled.
Open the OSD menu and select Power , select Auto-Sleep
Mode , and then set auto-sleep to On .
“OSD Lockout” is
displayed.
The monitor's OSD Lockout
function is enabled.
Press and hold the Menu button for 10 seconds to disable the
OSD Lockout function.
“Power Button
Lockout” is
displayed.
The monitor's Power Button
Lockout
feature is enabled.
Press and hold the Power button for 10 seconds to unlock the
power button function.

HP E243d Specifications

General

Screen Size	23.8 inches
Resolution	1920 x 1080
Panel Type	IPS
Aspect Ratio	16:9
Brightness	250 cd/m²
Contrast Ratio	1000:1
Stand Adjustments	Height, Tilt, Swivel, Pivot
HDCP Support	Yes
Integrated Speakers	No
Height Adjustment	150 mm
Pivot	Yes
Refresh Rate	60 Hz
Color Support	16.7 million colors
VESA Mount	100 x 100 mm
Response Time	5 ms
Built-in Devices	USB Hub
Viewing Angle	178° horizontal / 178° vertical
Connectivity	DisplayPort, HDMI, USB-C