17
8) Peel all tapes off the metal chassis, take out mylar sheet, unfix two bolts and seven pan head screws.
9) Take out IF BD and Power BD, disconnect all cables.
10) Unscrew USB board and take it out.
Take off screw from USB side board
11) Unscrew push-push webcam module from rear case.
Take off screw from rear cover
12) Peel off gasket, conductive fabric, foil, and tape.
13) Reverse the module, PUSH it to “OPEN” and unscrew webcam control board. Disconnect webcam control
board and pass the cable through the module
To Next Page
Loading...
